Plasma Bevel Cutting Machine

Plasma Bevel Cutting Machine

  1. DAMA plasma cutting bevel system is capable of cutting bevel preparation including single, double cut bevels such as the V,Y bevel.
  2. DAMA provide Zero Offset Bevel Head. The head works by rotating the torch around the end of the cutting tip which means the angle of the cut can be changed without the need to offset the machine beam. This results in much simpler and faster control over the angle of the plasma.
  3. No loop cut when bevel angle ≦30o
  4. Blind bevel or variable angle bevel.
  5. No cable twist.
  6. Protection:
  • Torch sensor break away protection.
  • Breakaway-ring protection.
  • Arc stop detection.

 

Model

Plasma bevel

Effective cutting width (mm)

2500

3100

4000

5000

6000

7000

8000

9000

Rails span (mm)

3500

4100

5000

6000

7000

8000

9000

10000

Effective cutting length

on request

CNC controller

Farley PDF TS

Plasma

HPR-130XD or HPR-260XD or HPR-400XD

Software

SigmaNest

Plasma Bevel head

DAMA Zero offset bevel head

Option

1.Oxy-Fuel cutting kit:

  • .One Oxy-Fuel torch with motorized torch lifter and station
  • Regulator & pressure gauge and manifold
  • .Oxy-Fuel cutting logic sequence control & operation panel

2.Add Motorized Oxy-Fuel torch

3.Oxy-Fuel cutting torch height sensor (capacitive)

4.Zinc Powder marking torch

5.Warter spray

6.Electrical ignition unit

7.Rail's extension unit : Per 3000mm/unit